GET THE IDEA...("the idea...") and get to work!
The Biefeld-Brown Effect Demo:
Result: The High Voltage was applied to a Saucer Shaper Airfoil Capacitor in the manner of the Townsend Brown discovery: that the positive side of a high voltage capacitor exhibits a motion or force. This effect
was configured to change the weight of a delicately balanced Saucer Shaped Airfoil Capacitor. When the high voltage was applied: the suspended Saucer weighed less!
It used a Capacitor/Diode Ladder...
It used a Transistor/Flyback first stage driver for the cap/diode ladder...
Notice the "tube" or capacitor/diode ladder on the left. This is the multiplier stage of the high voltage power supply. This ladder uses six 45kv Diodes and six 30kv "doorknob" capacitors.
The Central Section of Flying Saucer is stressed to be tight like a drum! The "X" shaped struts are tapped into place to produce tension upon the central sections (Six of them in the Hexagon Shaped Center Drum Section) This tension causes the Saucer to "ring" like a drum (with a Resonant Frequency!)
Little airplane motor to provide some conventional power to unit. Idea is that gas motor runs little generator giving 12 volts dc (along with some battery backup) Then electronics of Saucer run from electrical current @13.8 volts dc. Even a Multiple Wave Oscillator power supply (minaturized) or a flyback with a cap/diode ladder can be rigged up on board the Flying Saucer. It is the onboard high voltage effects that provide "power" to the flying saucer motor. The idea is to provide H.V. electrostatic effects to the skin of the saucer (the Biefeld/Brown effect). Some lifting and ducting effect from the gas motor is supplemented by the HV electrostatic effects on the skin of the saucer. Polarity is plus on topside; and negative on bottom side of saucer skin; with a neutral band around the middle edge.
|
It's not easy to build a flying saucer. Do you think the ETs are stupid? But maybe we can do it too. If the ETs can come here, then we can go there.We're
not so dumb.
